No data available.
Please log in to see this content.
You have no subscription access to this content.
No metrics data to plot.
The attempt to load metrics for this article has failed.
The attempt to plot a graph for these metrics has failed.
The full text of this article is not currently available.
Predicting the shock compression response of heterogeneous powder mixtures
1. High-Pressure Research Applications in Geophysics, edited by M. H. Manghnani and S. Akimoto (Academic Press, New York, 1970).
2. R. M. German, Powder Metallurgy Science (Metal Powder Industries Federation, New Jersey 1984).
3. R. W. Heckel, Trans. Metallurg. Soc. AIME 221, 671–675 (1961).
6. K. Kawikata and K.-H. Lüdde, Powder Technol. 4, 61–68 (1970).
11. Ansys, Inc., autodyn, Release 12.0, Canonsburg, PA, 2009.
12. CTH User's Manual and Input Instructions, CTH Development Project, Version 9.0, 2009.
14. H. Fischmeister and E. Arzt, Powder Metall. 26, 82–88 (1983).
15. E. Arzt, Acta Metall. 30, 1883–1890 (1982).
16. M. Meyers, S. Shang, and K. Hokamoto, in Shock Waves in Materials Science, edited by A. Sawaoka (Springer-Verlag, Tokyo, 1993).
20. W. Kingery, H. Bowden, and D. Uhlmann, Introduction to Ceramics (Springer, New York, 1976), pp. 704–767.
21. M. J. Readey and F. M. Mahoney, Sandia Report No. SAND95-2374, 1995.
24. D. A. Fredenburg, “ Shock compaction and impact response of thermite powder mixtures,” Ph.D. dissertation (Georgia Institute of Technology, 2010).
26. N. N. Thadhani, K. S. Vandersall, R. T. Russell, R. A. Graham, G. T. Holman, and M. U. Anderson, AIP Conf. Proc. 429, 553–556 (1998).
27. R. G. McQueen, S. P. Marsh, J. W. Taylor, J. N. Fritz, and W. J. Carter, in High-Velocity Impact Phenomena, edited by R. Kinslow (Academic Press, New York 1970), pp. 294–419.
Article metrics loading...
A model framework for predicting the dynamic shock-compression response of heterogeneous powder mixtures using readily obtained measurements from quasi-static tests is presented. Low-strain-rate compression data are first analyzed to determine the region of the bulk response over which particle rearrangement does not contribute to compaction. This region is then fit to determine the densification modulus of the mixture, , an newly defined parameter describing the resistance of the mixture to yielding. The measured densification modulus, reflective of the diverse yielding phenomena that occur at the meso-scale, is implemented into a rate-independent formulation of the P-α model, which is combined with an isobaric equation of state to predict the low and high stress dynamic compression response of heterogeneous powder mixtures. The framework is applied to two metal + metal-oxide (thermite) powder mixtures, and good agreement between the model and experiment is obtained for all mixtures at stresses near and above those required to reach full density. At lower stresses, rate-dependencies of the constituents, and specifically those of the matrix constituent, determine the ability of the model to predict the measured response in the incomplete compaction regime.
Full text loading...
Most read this month