banner image
No data available.
Please log in to see this content.
You have no subscription access to this content.
No metrics data to plot.
The attempt to load metrics for this article has failed.
The attempt to plot a graph for these metrics has failed.
Stress creation during Ni–Mn alloy electrodeposition
Rent this article for
View: Figures


Image of FIG. 1.
FIG. 1.

Measured Mn concentration vs deposition rate for the Mn and Mn baths.

Image of FIG. 2.
FIG. 2.

Stress thickness vs thickness plot for three samples all grown at , where the Mn concentration was varied in the bath from .

Image of FIG. 3.
FIG. 3.

Stress thickness vs thickness plot for three samples grown using the Mn bath. The upper and lower curves were deposed at constant rates of 15 and , respectively, and the current density in the middle curve was cycled between 15 and , for 0.67 and , respectively.

Image of FIG. 4.
FIG. 4.

Difference between the stress as function of Mn concentration at constant current density for the three baths, 0, 2.5, and Mn.

Image of FIG. 5.
FIG. 5.

XRD pole figures showing similar texture for two samples (0 and Mn) both deposited at .

Image of FIG. 6.
FIG. 6.

XRD measured percent of microstrain as a function of Mn concentration. Note that error bars are for 1 sigma.


Article metrics loading...


Full text loading...

This is a required field
Please enter a valid email address
752b84549af89a08dbdd7fdb8b9568b5 journal.articlezxybnytfddd
Scitation: Stress creation during Ni–Mn alloy electrodeposition