No data available.
Please log in to see this content.
You have no subscription access to this content.
No metrics data to plot.
The attempt to load metrics for this article has failed.
The attempt to plot a graph for these metrics has failed.
The full text of this article is not currently available.
Sliding-mode control of single input multiple output DC-DC converter
M. Anun, M. Ordonez, I. G. Zurbriggen et al., “Circular switching surface technique: High-performance constant power load stabilization for electric vehicle systems,” IEEE Trans. Power Electron. 30(8), 4560–4572 (2015).
F. Gao, T. Yang, L. Zhang et al., “An integrated electric vehicle power conversion system using modular multilevel converter,” in IEEE Energy Conversion Congress and Exposition (ECCE) (IEEE, 2015), pp. 5044–5051.
P. S. Mohanbhai and P. P. Mohanbhai, “Effective power and energy management for the dual source hybrid electric vehicle based on the measured drive cycle,” in IEEE 5th India International Conference on Power Electronics (IICPE) (IEEE, 2012), pp. 1–6.
A. S. Patil and H. T. Jadhav, “A ZCS high efficient single input multiple output DC-DC converter with step up capability,” in International Conference on Electrical, Electronics, Signals, Communication and Optimization (EESCO) (IEEE, 2015).
E. Bonizzoni, F. Borghetti, P. Malcovati, F. Maloberti, and B. Niessen, “A 200 mA 93% peak efficiency single-inductor dual-output DC-DC buck converter,” Analog Integr. Circuits Signal Process. 62, 526–619 (2007).
E. Bayer and G. Thiele, “A single-inductor multiple-output converter with peak current state-machine control,” in Twenty-First Annual IEEE Applied Power Electronics Conference and Exposition. APEC ’06, 19–23 March 2006 (IEEE, 2006), p. 7.
S.-C. Koon, Y.-H. Lam, and W.-H. Ki, “Integrated charge-control single-inductor dual-output step-up/step-down converter,” in IEEE International Symposium on Circuits and Systems May 2005 (IEEE, 2005), Vol. 4, pp. 3071–3074.
M. W. May, M. R. May, and J. E. Willis, “A synchronous dual-output switching DC-DC converter using multibit noise-shaped switch control,” in IEEE International Solid-State Circuits Conference. Digest of Technical Papers (IEEE, 2001), pp. 358–359.
A. Pizzutelli and M. Ghioni, “Novel control technique for single inductor multiple output converters operating in CCM with reduced cross-regulation,” in Twenty-Third Annual IEEE Applied Power Electronics Conference and Exposition (IEEE, 2008), pp. 1502–1507.
M. Belloni, E. Bonizzoni, E. Kiseliovas, P. Malcovati, F. Maloberti, T. Peltola, and T. Teppo, “A 4-output single-inductor DC-DC buck converter with self-boosted switch drivers and 1.2 A total output current,” in IEEE International Solid-State Circuits Conference—Digest of Technical Papers (IEEE, 2008), pp. 444–626.
A. Sharma and Y. S. Pavan, “A single inductor multiple output converter with adaptive delta current mode control,” in IEEE International Symposium on Circuits and Systems (IEEE, 2006), pp. 5643–5646.
Y.-J. Woo, H.-P. Le, G.-H. Cho, G.-H. Cho, and S.-I. Kim, “Load-independent control of switching DC-DC converters with freewheeling current feedback,” in IEEE International Solid-State Circuits Conference—Digest of Technical Papers (IEEE, 2008), pp. 446–626.
P. Dai, S. Cauet, and P. Coirault, “Passivity-based control and sliding mode control of hybrid DC power source applied to hybrid electric vehicles,” in 3rd International Conference on Systems and Control (IEEE, 2013), pp. 691–696.
R. Ling, M. Wu, Y. Dong, and Y. Chai, “High order sliding-mode control for uncertain nonlinear systems with relative degree three,” Commun. Nonlinear Sci. Numer. Simul. 17(8), 3406–3416 (2012).
J. Wang, S. Li, J. Fan et al., “Nonlinear disturbance observer based sliding mode control for PWM-based DC-DC boost converter systems,” in The 27th Chinese Control and Decision Conference (IEEE, 2015).
S. Cauet, P. Coirault, and M. Njeh, “Diesel engine torque ripple reduction through LPV control in hybrid electric vehicle powertrain: Experimental results,” J. Control Engineering Practice 21(12), 1830–1840 (2013).
Y. Wang, H. Xia, and Y. Cao, “Voltage controller of DC-DC buck converter using terminal sliding mode,” in IECON 2015—41st Annual Conference of the IEEE Industrial Electronics Society (IEEE, 2015).
S. Dwari, S. Jayawant, T. Beechner, S. K. Miller, A. Mathew, M. Chen, J. Riehl, and J. Sun, “Dynamics characterization of coupled-inductor boost DC-DC converters,” in IEEE Workshops on Computers in Power Electronics (IEEE, Troy, NY, USA, 2006).
P. Patra, A. Patra, and N. Misra, “A single-inductor multiple-output switcher with simultaneous buck, boost and inverted outputs,” IEEE Trans. Power Electron. 27(4), 1936–1951 (2012).
A. Nami, F. Zare, A. Ghosh, and F. Blaabjerg, “Multiple-output DC–DC converters based on diode-clamped converters configuration: Topology and control strategy,” IET Power Electron. 3(2), 197–208 (2010).
C. Mullett and F. Cathell, “Improving the regulation of multi-output flyback converters,” in Twenty-Fourth Annual IEEE Applied Power Electronics Conference and Exposition (IEEE, Palm Springs, USA, 2009), pp. 1923–1926.
M. Huang and K. Chen, “Single-inductor multi-output (SIMO) DC-DC converters with high light-load efficiency and minimized cross-regulation for portable devices,” IEEE J. Solid-State Circuits 44(4), 1099–1111 (2009).
H.-P. Le, C.-S. Chae, K.-C. Lee, S.-W. Wang, G.-H. Cho, and G.-H. Cho, “A single-inductor switching DC-DC converter with five output and ordered power-distributive control,” IEEE J. Solid-State Circuits 42(12), 2706–2714 (2007).
S. Chong Tan, Y. M. Lai, and C. K. Tse, “General design issues of sliding-mode controllers in DC–DC converters,” IEEE Trans. Ind. Electron. 55(3), 1160 (2008).
Article metrics loading...
Various voltage levels are required in the vehicle mounted power system. A conventional solution is to utilize an independent multiple output DC-DC converter whose cost is high and control scheme is complicated. In this paper, we design a novel SIMO DC-DC converter with sliding mode controller. The proposed converter can boost the voltage of a low-voltage input power source to a controllable high-voltage DC bus and middle-voltage output terminals, which endow the converter with characteristics of simple structure, low cost, and convenient control. In addition, the sliding mode control (SMC) technique applied in our converter can enhance the performances of a certain SIMO DC-DC converter topology. The high-voltage DC bus can be regarded as the main power source to the high-voltage facility of the vehicle mounted power system, and the middle-voltage output terminals can supply power to the low-voltage equipment on an automobile. In the respect of control algorithm, it is the first time to propose the SMC-PID (Proportion Integration Differentiation) control algorithm, in which the SMC algorithm is utilized and the PID control is attended to the conventional SMC algorithm. The PID control increases the dynamic ability of the SMC algorithm by establishing the corresponding SMC surface and introducing the attached integral of voltage error, which endow the sliding-control system with excellent dynamic performance. At last, we established the MATLAB/SIMULINK simulation model, tested performance of the system, and built the hardware prototype based on Digital Signal Processor (DSP). Results show that the sliding mode control is able to track a required trajectory, which has robustness against the uncertainties and disturbances.
Full text loading...
Most read this month