Review of Scientific Instruments
Search:
   
 
 
 
Previous Article
Deterministic fabrication of carbon nanotube probes using the dielectrophoretic assembly and electrical detection
We report the controlled dielectrophoretic assembly for the deterministic fabrication of carbon nanotube (CNT) probes. Electrical detection was applied to the dielectrophoretic assembly of CNT probes....
Next Article
Original use of a direct injection high efficiency nebulizer for the standardization of liquid fuels spray flames
It is of practical importance to lead laboratory-scale experiments allowing a better understanding of the impact of commercial fuels composition on the formation of combustion residues such as soot pa...

Improvement of spatial resolution for local Seebeck coefficient measurements by deconvolution algorithm

Rev. Sci. Instrum. 80, 105104 (2009); doi:10.1063/1.3246815

Published 19 October 2009

You are not logged in to this journal. Log in

K. H. Wu,1 C. I. Hung,1 P. Ziolkowski,2 D. Platzek,2,3 G. Karpinski,2 C. Stiewe,2 and E. Mueller2
1Department of Mechanical Engineering, National Cheng Kung University, Tainan 70101, Taiwan
2Institute of Materials Research, German Aerospace Center (DLR), Cologne D-51170, Germany
3Physics Technology—Development and Consulting (PANCO), Muelheim-Kaerlich D-56218, Germany

A potential Seebeck microprobe apparatus is described such that a profile of Seebeck coefficients can be detected on a material sample surface for thermopower investigations. Due to its spatially resolved limit on detecting small inhomogeneities of dopants or composition changes, we here propose a constructive combination of numerical modeling and practical measurement to improve the spatial resolution by deconvolution algorithm. The relevant transfer function, obtained from numerical calculations, was successfully applied on real measurement data. Besides, an improvement in detecting the 1.5  µm inhomogeneity has been achieved by applying one transfer function of the known tip setup on a set of Seebeck line scan signals, obtained with 6  µm tip-sample contact length, 3  µs signal capture time after contact, and 0.75  µm scan period. The result showed that a system theoretical approach in terms of deconvolution algorithm could theoretically enhance the spatial resolution anyway, but is practically limited by the systemic preconditions (tip size, signal capture time, and scan period) and the signal to noise ratio of the captured thermovoltages. Therefore, we provide a clear understanding of systemic preconditions and their impacts on the detection of small inhomogeneities and thus the performance in the thermopower analysis. ©2009 American Institute of Physics
History: Received 30 April 2009; accepted 19 September 2009; published 19 October 2009
Permalink: http://link.aip.org/link/?RSINAK/80/105104/1
BUY THIS ARTICLE   (US$24)
Download PDF (1055 kB) View Cart

KEYWORDS and PACS

Keywords
PACS
  • 72.15.Jf
    Thermoelectric and thermomagnetic effects (metals/alloys)
  • 71.10.-w
    Theories and models of many electron systems in condensed matter
  • 84.32.Hh
    Inductors and coils; wiring
  • YEAR: 2009

RELATED DATABASES


To view database links for this article,
you need to log in.
To view database links for this article,
you need to log in.

PUBLICATION DATA

ISSN:
0034-6748 (print)   1089-7623 (online)
Publisher:
AIP is a member of CrossRef AIP

REFERENCES (21)

For access to fully linked references, you need to log in. For access to fully linked references, you need to Log in.
  1. J. G. Vián and D. Astrain, Appl. Therm. Eng. 28, 1514 (2008).
  2. B. Poudel, Q. Hau, Y. Ma, Y. Lan, A. Minnich, B. Yu, X. Yan, D. Wang, A. Muto, D. Vashaee, X. Chen, J. Liu, M. S. Dresselhaus, G. Chen, and Z. Ren, Science 320, 634 (2008).
  3. K. F. Hsu, S. Loo, F. Guo, W. Chen, J. S. Dyck, C. Uher, T. Hogan, E. K. Polychroniadis, and M. G. Kanatzidis, Science 303, 818 (2004).
  4. X. B. Zhao, H. Y. Chen, E. Mueller, and C. Drasar, Appl. Phys. A: Mater. Sci. Process. 80, 1123 (2005).
  5. H. Y. Chen, X. B. Zhao, C. Stiewe, D. Platzek, and E. Mueller, J. Alloys Compd. 433, 338 (2007).
  6. Z. Dashevsky, S. Shusterman, M. P. Dariel, and I. Drabkin, J. Appl. Phys. 92, 1425 (2002).
  7. R. Yang, G. Chen, and M. S. Dresselhaus, Phys. Rev. B 72, 125418 (2005).
  8. Z. He, C. Stiewe, D. Platzek, G. Karpinski, E. Mueller, S. Li, M. Toprak, and M. Muhammed, Nanotechnology 18, 235602 (2007).
  9. A. A. Nikolaeva, D. V. Gitsu, T. E. Huber, L. A. Konopko, and Gh. Para, Phys. Status Solidi C 1, 2654 (2004).
  10. C. Dames and G. Chen, J. Appl. Phys. 95, 682 (2004).
  11. P. Reinshaus, H. Suessmann, M. Bohm, A. Schuck, and T. Dietrich, Proceeding of the Second European Symposium on Thermoelectrics—Materials, Processing Techniques and Applications, 1994 (unpublished), p. 90.
  12. D. Platzek, G. Karpinski, C. Stiewe, P. Ziolkowski, C. Drasar, and E. Mueller, Proceeding of the 24th International Conference on Thermoelectrics (ICT), 2005 (unpublished), p. 13.
  13. N. Chen, F. Gascoin, G. J. Snyder, E. Mueller, G. Karoinski, and C. Stiewe, Appl. Phys. Lett. 87, 171903 (2005).
  14. J. Zhou, S. Li, H. M. A. Soliman, M. S. Toprak, M. Muhammed, D. Platzek, and E. Mueller, J. Alloys Compd. 471, 278 (2009).
  15. M. S. Toprak, C. Stiewe, D. Platzek, S. Williams, L. Bertini, E. Mueller, C. Gatti, Y. Zhang, M. Rowe, and M. Muhammed, Adv. Funct. Mater. 14, 1189 (2004).
  16. H. L. Ni, X. B. Zhao, G. Karpinski, and E. Mueller, J. Mater. Sci. 40, 605 (2005).
  17. H. K. Lyeo, A. A. Khajetoorians, L. Shi, K. P. Pipe, R. J. Ram, A. Shakouri, and C. K. Shih, Science 303, 816 (2004).
  18. Z. Bian, A. Shakouri, L. Shi, H. K. Lyeo, and C. K. Shih, Appl. Phys. Lett. 87, 053115 (2005).
  19. E. Mueller, Č. Drašar, J. Schilz, and W. A. Kaysser, Mater. Sci. Eng., A 362, 17 (2003).
  20. E. E. Antonova and D. C. Looman, Proceeding of the 24th International Conference on Thermoelectrics (ICT), 2005 (unpublished), p. 215.
  21. P. Ziolkowski, G. Karpinski, D. Platzek, C. Stiewe, and E. Mueller, Proceeding of the 25th International Conference on Thermoelectrics (ICT), 2006 (unpublished), p. 684.

CITING ARTICLES

For access to citing articles, you need to log in.
For access to citing articles, you need to Log in.